Engine Light on and Restricted performance message on Jaguar S-Type You need to take to Jaguar technician to have Mil lamp codes read and cured the restricted performance is the engine protecting itself as there is a fault in the management system,usually fuel system related,It has gone into "Limp Home" mode to try to limit the damage done Got my 2,7D S Type in February, Whilst driving to Spain the amber, restricted performance light came on, just after setting off mid France, early morning. Stopped the car, waited 5 min's, then re-started. First Name: Jon. Jaguar Model: XF. Year of Jaguar: 2017. Location: Sussex. Posted April 20, 2021. Hi All, Yesterday I had the dreaded "Restricted Performance" message. Today it was gone until about 20 miles away from home. I know it needs to be plugged in and diagnosed, but my local indy dealer is awash with work after lockdown. Posted October 31, 2011. Welcome to the Jaguar Owners Club Richard. It could be a faulty connection within the ABS pump module or a dirty ABS wheel speed sensor. Give the ABS sensors a clean and if that doesnt work try the ABS pump module. Eliminate those first. Found and fixed another restricted performance culprit. I had RS coming up after driving and pushing it a bit, ie right round the rev range changing up. Didn’t come up straight away but after 10mins of sprinted driving or acceleration at motorway speeds. Looking under bonnet I found what I though was initially the problem, the crankcase vent The car would run ok but then drop into Restricted Performance once it began to cruise on a light throttle. The fault code showed the offside (ie:driver's side) EGR valve faulty. It cost me £288 to get it replaced at an Indy, more expensive because this side is an absolute swine to get to. The passenger side EGR valve is easier to replace. My 2005 Jag S-Type 6 cylinder check engine light came on and while in parked position the check engine light started to blink yellow and stated "Restricted Performance" what does that mean? You have a fault condition in the the engine management system - get the codes read to indicate where the fault lies 1. Run engine at about 2,000 rpm for about 2 minutes under no-load. 2. Rev engine (2,000 to 3,000 rpm) two or three times under no-load, then run engine at idle speed. 3. Turn off engine and disconnect throttle position sensor harness connector. 4. Vay Tiền Trả Góp 24 Tháng.

jaguar s type restricted performance